Install was easy and required only minimal wiggling with the car on the ground but there were two problems: The brace was touching the intake manifold. And when I took the brace off there was a scuff mark to prove it. Also the cruise control bowden cable was crushed under the bar. I was mostly concerned about the the contact between the bar and manifold so I emailed Ireland Engineering and the response was basically
“It is just kind of parr for the course, but you can bend the bar slightly there (or a decent wack with a hammer [after heating up the bar to a good couple hundred degree’s right there as to keep the p.c. from cracking]).”
And this is where I’ll review the product:
If you’re looking for a bar that should fit and have better build quality then I will pass on the recommendation I received, which is the UUC Strutbarbarian. This bar has a bracket to reroute cruise control which shows some thoughtful design. Though I have heard horror stories about UUC build quality (specifically brand new parts breaking during track events) but I believe that the strut bar is a simple enough thing that it can be trusted not to break.
Hindsight is always 20/20. I got my tools and set about modding the bar. I’m not experienced with fabrication but after only a couple of hits I realized that the powder coating was not going to stay on the bar and I’d have to touch up with regular paint. Thankfully this part isn’t visible because it’s between the bar and the intake manifold.
The next project related to this will be sorting out the cruise control cable.
© 2019 BMW life | Theme by Eleven Themes